C76 - UC300ETH Multifunction Board.
好友建房炸金花the c76 supplies full access to the power of the uc300eth board. it emulates 5 ports for discrete signals and a port for analogs. it allows wiring ttl or industrial type open collector inputs and outputs.
The C76 supplies full access to the power of the UC300ETH board. It emulates 5 ports for discrete signals and a port for analogs. It allows wiring TTL or industrial type Open Collector inputs and outputs.
Designed for UC300ETH motion controller.
3 Expansion Ports
Built-in PWM-Based Speed Control and Two Built-in Electromechanical Relays with NO and NC positions for spindle control.
Monitors E-Stop, Safety Charge Pump, Driver Fault and VFD Fault.
It is compatible with family of C34 connector boards that allow quickly connecting to popular drives connecting not just the step and direction signals, but also the fault and enable signals.
Electromechanical Relay with NO and NC positions for general purpose (Port_2 16 or 17, jumper-selectable). If tied to pin 17 The relay will remain active while the system is active, making it ideal to control the power to the system.
Independent Optoisolation Circuits for each port.
Power terminal (10-30VDC). This can power the entire logic of the system.
Outputs +3.3vdc at 24mA TTL.
Status LEDs on all inputs connections.
18 inputs ports.
Flexible Driver Connection.
Analog I/O port pinout.
Documents and Download
Software, Installers and Configuration Files
Frequently Asked Questions and Answers
- What is a Safety Charge Pump (SCHP)?
It is a watchdog. It is a feature in which the control software will send a pulse stream through a pin, as if it was moving an axis. Then a microcontroller on the breakout board will see that pulse stream and will know that the signals coming f...
- I cannot get the green LED to enable on the breakout board
3 conditions must be met to get the enable led:
- The board must be properly powered. Check the documentation on the board, as a misunderstanding on how it is powered is very possible.
- The board must be connected to a ...
- US and International modes of operations for VFDs (Variable Frequency Drives) and Speed Controllers
VFDs and motors have two way of operation, in the US we use CW and CCW, in the rest of the world, or INT (International) it is used START/STOP and DIRECTION. These settings can usually be adjusted VFD settings. The chances are that if you purchased th...